Instructions:
1.Reverse polarity protection and short circuit protection.(warning beep)B
2.AC 100-240V exchange switch for international specification.
3.Supply 3.6V / 3.7V 2-4 cells Li-ion/Li-polymer battery.
4..For both balance charge and charging in series. It is a fast, convenient design.
5.Balance charging is good to prevent the situation of over-charging or under-charging for a single cell.
6.Auto-detected charge status display. (Red light: while charging Green light: end of charging)
7.Cooling fan and multi-circuit protection to avoid the dangerous of charging.
8.The auto-detected function of low voltage for power storage.

Charge Method:
1.Series DC7.4V JST connector X 2 sets (no more parallel charge plug in)
2.Series DC11.1V 20A connector X 1 set(no more parallel charge plug in)
3.Balance DC7.4V connector X 2 sets
4.Balance DC11.1V connector X 1set
5.Balance DC14.8V connector X 1 set(avalible refit to DC11.1V balance connector )
Single cell circus can be parallel charging 2 sets at the same time by balance charging. Divide up 500mAh for 2Cell. The maximum suggestion is 8cell for parallel charging.

- approval(GTK-0503030)A approval(GTK-0503118)B

NOTE:
Do not leave the charger is operating unattended as it may cause a fire.

Specification:
- Dimension: Length 135 x width 80x height 35 (mm)
- Series no: RCC-4CX
- Input Voltage: AC 100-240V 50-60Hz
- Output Voltage: 2cell DC 7.4V
3cell DC 11.1V
4cell DC 14.8V
- Output Current: 1000 mA/cell

Precaution:
Note!
If the battery becomes hot while high current discharging or flying, please do not charge the battery immediately. Wait to cool down(about 20 mins), then inspect to recharge. If against follow the original factory using rules, possibly cause the battery to inflate or any dangerous accident happens.

- Recommend this Li-ion/Li-polymer charger for the safty and efficiency of battery.